Recent content by jline24

actually it broke

after having wife pull me while I tried to engage I realized it wasn't a trans or hydro issue. pin fell out

Also, I'd like to put the cover back on. what kind of gasket do I need? thanks

I've got an RK24H about 300 hours, did service a couple months ago. Was running just fine. Was moving pallets, ran over and picked up a stack, backed up, turned around set the stack down and hopped off to grab a couple pieces. I get back on, raise the loader and push the throttle. Nothing...

Thanks for the help I'm calling the hydraulic shoo I found tomorrow they have the controller and power beyond fitting for the controller totalling about $350. far better than almost a grand. I hate politics and think all politicians endow a certain level of false sense of entitlement, greed...

Does anyone know where I can get the power beyond adapter? its a samwoo model valve control I'm afraid to start spending 30-100 dollars for things that won't work I have emergency cash but this does not meet our definition to use that to get a new control, but i make reclaimed wood tables...

I did buy another 2 spool, single action. Issue is that the ports are 7/8-14 and the OEM is 5/8 to 3/8 so I would have to... A) Buy a bunch of fittings to go from the 7/8 down to the 3/8 hose which I priced out and was over $120. B) Buy new 1/2 hoses (7/8 to 1/2 fittings as well also well...

I just realized something and I have to apologize I bought a replacement controller on amazon but the power beyond fitting didn't fit I was in a rush and cut the tip off to "make" it fit it was an o ring that no longer exists. would that be the issue?

Thanks for the response... When I first looked at the knob before I touched anything (after seeing the issue) it was 2/3 to the right (FEL). I have tried turning it all the way to the right and left and eventually put it back where it was I did the same with the knob under the seat...

OK, just ran the test. #1-2 with tractor on, raised FEL all the way up and curled bucket left at that position. When trying to raise PTO hitch nothing happens. #3 While holding PTO in lift position, uncurling bucket did nothing but lowering the FEL while hold hitch lever at raise the arms...

Just went to RK and looked at a new RK24H and the hoses are correct on my tractor. I did notice the PTO lift lever on the new has much more spring than mine. mine doesn't have the same resistance. could a valve be stuck open?

I failed to mention there is a 3rd hydraulic hookup on the right for an optional attachment. not sure if that would be in play

Well, I just can't seem to figure it out. hoses look right (P, T, C). But I can't find any diagrams that really give good detail. I'm going to go to Rural King tomorrow and look at the 24Hs they have sitting out. Maybe that will help. Could it be low fluid? I put fluid in until it was...

OK I'll take a look. I haven't seen any documents that say to bleed the lines. If I can figure out the lines do I need to bleed them? the loader has been fine. its got full power and doesn't jump or have dead spots

OK, if I hold the PTO lift lever at lift position and raise the bucket nothing. But if I lower the front loader the PTO hitch raises. Same with tilt, but it moves a little faster. if I hold PTO lift lever at lift and tilt bucket up hitch raises