Recent content by jhp123

I purchased a new instrument panel for a1965 ford 5000. The old one had one working item...the temperature gauge. The replacement panel is hooked up. Tach, background lights, generator light and oil pressure lights all work fine. Fuel gauge however, comes "on" when key is in the run position...

What kind of oil goes in the front axle of a 1988 Case 885xl?

I have a 1975 9600 with six cylinder diesel. Fuel is coming out of the fuel injector on the side up against the motor. I can't see exactly where it's coming from. it doesn't leak while idling, but it begins to leak in a small stream coming from the engine side of the pump when the engine is...

1965 Ford 5000 3 point will not lift or will lift a little but not with any weight on it. We put a new pump and changed all the little o-rings as well as the lift cylinder o ring and wiper on it. It worked for a little while, maybe a couple of weeks, then went un-responsive again. Any other...

I have a 1988 case 885xl mfwd with the lighted switch underneath the steering column to engage the 4 wheel drive. While using the tractor I experience a "clunk clunk" sound and the 4 wheel drive quit working. Light still works at switch. We listened for the solenoid down at the transfer case...

We have installed a new hydraulic pump on a 65 ford 5000, it came with a new pressure relief valve and a new filter. The filter has been replaced that is attached to the lift cylinder. The o-rings have been replaced at pump(where it meets the case), the o-ring between the case and the top lid...

I lost my key to a 2000 new Holland 1920. My other keys to my older tractors don't cross over like they do with each other. Can I go to a dealer and just get a key or do I have to change out the ignition switch?

My tractors get somewhere around 100-150 hrs. of use in a given year. How long should I go before changing hydraulic fluid?

I have a 1965 Ford 5000. The 3 point stopped working suddenly will not lift at all, even without a load. PTO still turns. Am I looking at a new hydraulic pump? Are there some more common smaller part failures that may cause this? If so, which one would you think is the most likely? We don't have...

I have a 1965 Ford 5000. The 3 point stopped working suddenly will not lift at all, even without a load. PTO still turns. Am I looking at a new hydraulic pump? Are there some more common smaller part failures that may cause this? If so, which one would you think is the most likely? We...

I broke my rear glass on my 1988 Case 885 any suggestions on where to find a replacement?

We have a 1975 ford 9600 6 cylinder tractor. While running, diesel fuel is coming out of the small tube (overflow) on the fuel injector pump. Engine is running fine but the fuel is coming out pretty fast out of the tube. The pump is exactly like my 5000 with the exception of the 2 extra ports...

We have a 1975 ford 9600 6 cylinder tractor. While running, diesel fuel is coming out of the small tube (overflow) on the fuel injector pump. Engine is running fine but the fuel is coming out pretty fast out of the tube. The pump is exactly like my 5000 with the exception of the 2 extra ports...

I have a Ford 5000 that had hydraulic fluid coming out of the top of the steering wheel. We took it apart and replaced the seal inside that goes around the steering shaft. After we put it back together and added the fluid back it would turn to the right very well but turning back to the left was...

I have a Ford 5000 that had hydraulic fluid coming out of the top of the steering wheel. We took it apart and replaced the seal inside that goes around the steering shaft. After we put it back together and added the fluid back it would turn to the right very well but turning back to the left...