Recent content by IslandManMitch

I have acquired a Kubota WG-600-B 3 cylinder gas engine. Original installation unknown. The two wires coming from the distributor are not connected. The repair manual shows they connect to the + and - side of the coil but not which wire to which side. I am hesitant to guess because I may fry...

Sorry for the double post.

This is the cylinder that has been used for a top link. It was used cylinder and retrofitted years ago and has worked fine except it has always leaked a little. Getting worse and it is to the point it needs rebuilding. The rod end cover had two 1/4" bolt holding it on which I removed. I put the...

Hooked up the bush hog to my 4600 yesterday and no pto? The dash light comes on and if you raise off the seat the engine dies like it is running. I have 12 volts to the solenoid. Ohm meter says I am getting continuity through the solenoid. A new solenoid is about a hundred bucks and I want to...

I bought my 4600 used a couple of years ago and the original owner told me sometime when it won't start you have to crack an injector line. I ran it for months and one day it would not start, crack injector line and she started. Over the past couple of years it has happened off and on and...

I bought a used Bushhog rotary cutter that appears to be in excellent condition. The man I bought it from said he had only used it twice to cut 5 acres and it looks like it. He said he had done nothing to it since buying it from dealer. My question it the oil level in the gear box. It has two...

I have JD 4600 with a 460 loader and 48 backhoe. The selective control valve (SCV) operates the front-end loader stopped curling the bucket. I found the problem to be the center Load check valve. The online JD parts catalog does not break down the SVC enough to get a part number. The local...