Harry in Ky's latest activity

You seem to have a lot going on here, and a lot being thrown at you. Some of which I agree with, some not so much. For one thing, while...

An easier way to have a bit of a visual check? That depends on just how the tractor cases are designed. Sometimes there removable covers...

In most cases bleeding won't be necessary. What exactly are we doing here? Are you looking for answers concerning a problem you're "not...

Hard to say. What did you add and how/where did you add it? Something obviously changed if it raised the front end before the addition...

A cause for concern? Yes and no. That style cylinder will have a wire ring just inside the barrel that can be removed for cylinder...

Reducing the free play will add some stroke to the "disengagement" action inside, yes. BUT it's uncommon among typical clutch related...

It's quite possible you noise is external not internal at all. Check the wheel bolts where the center dish bolts to the rim. This is a...

No disrespect here, but the PTO is on the left side. Misinformation isn't helpful.

For openers, I agree with "mechanic guy" that rust on the flywheel shouldn't be an issue. Next point. Assuming the "starter guy" took...

You probably should provide a little more history of the situation if you expect any meaningful replies. Pulling injectors is a "last...

Actually, I think you have it backwards. The power beyond port on the loader valve connects back into the lift system. The port that...

A lever near the transmission dipstick would be the raise response lever. The concept is this lever affects how far the position control...

"Will turn over but not fire at all". That leaves a lot of room for speculation from out here. Are you seeing any smoke while cranking...

You need to revisit the entire plumbing package. Your second photo shows what appears to be a power beyond sleeve, so the line from that...

I would unscrew the gland nut BEFORE removing the barrel end pin. Much easier while it's still anchored.