Harry in Ky's latest activity

You need to get rid of the tee on the existing power beyond fitting. You need a power beyond sleeve in the new valve (and yes, It's way...

If the three point will hold a load for even twenty minutes the piston seals are not the problem. No need to remove the pump mounting...

Then it's not a filter or oil related problem. It's strictly something in the hydraulic pump pressure circuits or the pump itself. Are...

A couple observations. It looks like the tractor had an engine driven pump at one point, and someone removed it and most of the...

Does the power steering work? Does it have two separate pumps or one twin stack pump?

I think detaching the loader and removing the entire cylinder is the wrong way to go. You're turning a two hour job into three day's...

I don't see why not. It wouldn't be that much different. With the rod end still anchored it will easy to break the nut loose so the...

You're looking at it, I'm not. That said, you may be looking at way more work than necessary. Many of us have installed seals in many...

Trying to find it through Mahindra is a possibility, but could be problematic. If I had this problem I would remove the line, cut the...

Deal with the tank. Don't worry about the pump. Messing around there will only do more harm than good.

Not that it really matters, but while it was off did you bench test it with 12v to see what moved when power is applied and removed? At...

Then that's a different problem. Look for this sender in the thermostat housing and unplug it. Then look for any blown fuses in the...

Okay, so videos aside, how did all this work out?

Some manufacturers actually stamp part numbers onto the barrel somewhere but not many. As a general rule I don't deal with seal "kits"...

You're getting deeper by the minute. The 4WD shifter, lever, gears, shafts, ETC will have no effect on the tractor moving on its own...