flyerdan's latest activity

Somewhere on the tank there should be a triangle symbol with a number in it, that will tell what type of plastic it is, and what rod is...

So a 49 million rise in premiums across the board for Kaiser then.

1st check would be battery post/terminals are clean and there is a good ground connection to the negative lead.

I'd start with the tag just to the right of the main gearbox. Maybe post a close up of it and it can be located that way.

If you can give me the ID, OD and width (or height) of the bearings and seals I might be able to find them in my big cross reference books.

A permanent mount where you can get all around it would eat up too much floor space, so I made a quick slide on base for one of my fork...

A ratcheting box end of the correct size should work on that, you might try an obstruction wrench. If the tailwheel bracket is welded...

It looks like it has a cable that pulls an idler pulley to tension the drive belt, chances are that the cable is gummed up, or has...

It sounds like a safety switch issue, test the start terminal on the ignition switch for +12v, then test the wire to the starter...

It looks like the bakelite housing will come off the back of that solenoid. You should be able to take it apart and clean the copper...

It doesn't make sense, the holes do caliper out different that the numbers they give, but that's what they're listed as. I have the big...

Type in loader in the select model box, then compact tractor from the menu.

Is this it?

Sounds like a piece of heat shrink tube on the brake pin would be good insurance, if it would allow the case to close, some of them have...

I'll bet sorting this one was fun...