Recent content by ErnieR

Well the LED flasher arrived and sure enough the positive and negative prongs coming off the flasher were opposite to the OEM but as you mentioned to use the supplied wires it worked like a charm. I also ordered a cell phone charger and installed it into the plastic dash and have 2 LED lights...

Can’t Thank you enough for all your help. Flasher is supposed to be here Saturday so fingers crossed it’ll solve things. I’ll let you know. Tnx again. Ernie

👍

Well hopefully this will do the trick because I just ordered it. Has a potentiometer on it to adjust speed.

Not sure what the letters represent or why anything more than 2 pins are required for blinkers…hmmmm plus this OEM flasher has a metal lug where it bolts up underneath the dash

I’ll finish reading your post soon as I have time to sit down but what a spot they had the flasher buried in. Is this what you or is called an electronic flasher ??

Well the 2 pack of BAU15S ambers arrived today and sure enough the flashers blink same speed as if a bulb is burnt out. So what options does that leave, back to incandescent again ?? Surely they has to be one type of LED that will work in this application

Haha hope that doesn’t change the possibility of a decent opinion you have of me

I ordered from Amazon.ca the amber 1156 and their supposed to be here tomorrow so we’ll see how they work. Also on the tractor I have the 1157’s have a red plastic lens in front of them so I thought just getting the white bulbs should suffice. You guys in the US have such the selection to...

I had an old 1157 LED I had bought years ago for my fishing boat navigation light and never installed it and I can’t get over how much brighter it is compared to the standard incandescent wow. So where would I go about looking for what type flasher this RX7320 has One thing that is supper...

Good to know. Not sure which brand LED’s you got but so many mixed reviews, either short life and excessive heat (which I find odd from any LED) but hard to know which ones to buy. Take a chance and get 4 bulbs for like $12 vs 10 for the same price haha

Well that’s quite the surprise, 3 outta 4 bulbs burnt out. Doesn’t that seem odd that a tractor with such low hours would burn those bulbs out like that ?? The one Amber 1156 has the outer finish pretty much bubbled off from heat. Reading Amazon reviews on most of these LED don’t seem too...

I couldn’t figure out what single and dual filament bulbs I had in this tractor because the stamping didn’t say 1156 and or 1157 although they sure looked like typical 1156/1157 and your photo confirmed they are just with different numbering. What’s your thoughts on converting to LED in their...

Let’s hope nothing funky going on similar to yours !! What I’ll do is put some small shrink tube around my test probe and just leave the very tip exposed Appreciate the help guys. I’ll get back with the results in the morning

Do you mean, the Pin at the bottom of the socket or bulb position is positive ?? and yes being the sockets sit tucked in tight that why I was and always hesitant to go in the a probe because I usually have a tendency to pop a fuse haha Surely me jumping that seat safety wouldn’t be part of...