dieselscout80's latest activity

Thanks

I don’t see part # 161 on the picture you posted. Can you post where said spring # 161 goes?

One thing I have a question about is how the RPM of the blades compares to the blade speed of engine driven mowers? I think high blade...

I have a PAS 225 and I would say it’s not enough power especially when I use the blower on it.

IRCC I called Baldwin Filters about that filter that’s also on my TC45DA and they had a cross reference for it. I’ll look for the...

I’m guessing you have an air leak in your fuel supply system between the pickup in the tank and the fuel injection pump. The leak...

There is a grease zerk in there. Carefully turn the rotor shaft until it comes into view.

I don't have any advice for which grease you should use for your knees but I think you would use a kneedle-point applicator.

At 76, I sometimes think that I should have one of my doctors install a zerk on each knee. Then I could give them a couple of shots each...

After using compressed air to clear the line supplying fuel from the tank to the filter mine ran fine. However, this past winter I...

Blow the fuel line back into the tank. Also dont go by the gauge. My tc40 shut off on my climbing a pile. Then the key wouldnt do...

Just checked my New Holland manual. Calls out for tractor fittings every 50 hours. Grease tractor once a year which is 30-35hrs./yr...

You’re joking right? You use your tractor 30 hours a year so everyone should grease theirs once a year? You realize some people put 30...

For as frequently as I use mine I need a holster...

I also carry a IR temperature gun in my truck and check my hubs regularly.