dicktill's latest activity

My point was they seem to be the same engine, adjusted differently ... From the sales brochure ... But looking at the owners manual...

Tach or not, it should be governed and incapable of over-revving except in some fault condition.

Maybe, but the early GC2300s with the Iseki 3cyl did not have a tachometer. Snowblowing or chipping, 20 years of wide open throttle, no...

Wow, just seeing this @dicktill , hope it gets taken care of quickly!

I normally run mine in the green zone too if needing the slightly more power or speed. . . If I remember right you have the 23 HP...

Tee hee. : (

bet that was not the first word out of @dicktill mouth.

All I can say is OUCH.....

Thanks everyone but I was looking for no politics, deliberations, judgements, or condescending opinions. Perhaps this is not the right...

She's my only gal, other than my wife. : ) It could be a good opportunity for me to finish the dozens and dozens of non-Fergie jobs on...

old gc2400 was instrumental in building 4 tomato trellis, each 8ft long and hinged for storage. used tractor to haul the lumber up...

Started out this morning with lifting the Z-TRAK up to touch up the blades ... Then had to rescue the John Deere due to operator...

That's too bad Dick, my Little Baby Fergie is like my right arm, don't know what I'd do without her ... Do you have another tractor...

I think it will be pretty hard for Massey to deny it as a warranty repair unless there is something really bad that the OP did like run...

Please keep us posted on what the Dealer says. I have a 2022 Massey and it would be nice to hear that Massey took care of it.