dfkrug's latest activity

Any photos?

The grease we used for the spools is the reddish lithium-based stuff in the grease gun. Silicone grease would be fine, too. The oil...

Here is another pilot control that needs help: an AGT Industrial KRW232 skidsteer. This joystick is slightly different than the above...

OK, James, I installed the springs into my friend's Diggit EM15, and we both like the improved feel. Adding more resistance to the the...

Yeah, it is hard to trust the factory or distributor when it comes to a lot of specs, especially weight. I like to see owners who...

Yes! Some of those early Kubotas have only suction filtration, and water contamination can turn the oil into a booger-like substance...

Yeah the rears are over 200 clams each. 12" wide and very high load capacity.

I think these 3-cyl Mitsubishi engines are also found in Kei trucks, so parts should be available.

I will bet top speed, on the level or downhill is maybe 35MPH in 6th gear.

Just got my Frontier fiber working this week. 500Mbps up and down, $48/mo. Replaces dual-bonded copper DSL, 28M/2M for $90/mo. Does...

My 3200 is for sale locally (San Jose), but no interest at $4500. I was driving it around yesterday and the master cylinder started...

This is one of the reasons I have never been a fan of the old flatheads. To get some clearance for the valves to seal, the OP will have...

Since the intake valve is open put your thumb on top of the exhaust valve and see if it turns. And then turn the engine over to close...

Tell me about it. The neighbor phones and says "Can you help my wife get the tractor started?" It was -30 and had sat in the wind for a...

...and the Tecumseh engines mostly have an oil pump for better lubrication of engine bearings. Just landed a free 5hp mower for my...