Cycledude's latest activity

I ended up jacking up the bucket, just enough and slowly tapping the pin out. Got everything reset and bucket is operating well and it’s...

Amen to that. I would call that abuse for sure. I'm guessing OP doesn't have a flexible top link or is dragging his brush hog (set too...

This brake of the lift arm seems pretty rare. The original broke, its was repaired and broke again. Then a new replacement broke, I'd...

I'm more worried about twisting that upper lift arm though, rather than breaking the bolt. Also, those parts are not cast. They can be...

Back in April of '23, my 3 point adjustable link (SBA370011581) broke: I've been told that, since they're cast, they can't be welded...

OP you were observant enough to notice. Most people would walk right past and not notice it. Good save

After learning my lesson the hard way I have saved major $$$ by buying replacement hoses from Fleet Farm stores, they have a very nice...

I have also learned that lesson the expensive hard way twice ! Hydraulic hose prices at different places can vary a lot .

Maybe this gives a better idea on the "winky wire". Don't mind my tractor's balls just hanging out in the wild. 🙃

You beat me to it. :ROFLMAO: It took me until the pic from @ptsg to figure out what a "winky wire" was.

I just use a quick hitch.

I use a thick rubber bungee cord to support the hydraulic toplink when not in use. It works well.

This was my solution. A link from an old chain and a hose clamp. The hook is the original top link holder. It's been holding perfectly...

I have also been using a loop of cord to support the hydraulic top link when not using it. Seems to mostly work very well for me. Yes I...

Good point. It is still under warranty. It is such a minor inconvenience at this point I haven't fooled with it. I should at least call...