Cycledude's latest activity
-
Cycledude reacted to AlbionWood's post in the thread Injector problem or something else? with
Good Post.
No, the injection pump is unaffected by inlet pressure. What was happening was it couldn't get enough fuel flow at the higher rpm... -
Cycledude replied to the thread R4 Tire Pressure.Sure is strange that LS didn’t put some kind of recommendations for tire air pressure in the owners manual. No pressure indicated on my...
-
For a softer ride I adjust tire pressure to the point where the tires bulge slightly with the maximum load they encounter. R4s have a...
-
That actually happened to me this last fall when I dumped the air out of rear tires for snow chain install. I jacked the rear of the...
-
Dealer set the pressures quite high and not evenly. Had 36psi in the fronts and the rears were 21psi on the left side and 24 psi on the...
-
On my NH TC45 I have 16 psi in the fronts 10x16.5 and 12 psi in the 17.5x24 rear tires. To get full contact with the rears I need to go...
-
Get one of the laser aimed thermometer. Run the tractor around a bit, and then take three reading on the tire surface or lugs. The...
-
I've looked through the owner's manual for my MT357HC to find nominal tire pressures for the R4's I have on this tractor. Nothing...
-
Ibelive what the tire says is donot exceed 30lbs in seating beed, 15lbs should be close for loaded tires on that size tire. I only run...
-
Cycledude reacted to oldnslo's post in the thread Calcium filled tires… Same pressure test? with Good Post.
Agree don’t look under inflated in that picture. We ran similar pressure with fluid vs without. I would suspect 12 - 15 PSI for a tire...
-
Cycledude replied to the thread Calcium filled tires… Same pressure test?.If you have Harbor Freight in your area https://www.harborfreight.com/search?q=Liquid%20tire%20air%20pressure%20gauge
-
Cycledude reacted to kozal01's post in the thread Sthil Commercial Line Trimmers with 4 Cycle engines (still require 50:1 fuel/oil mix) - any experience with Good Post.
I measure with my arms, I'm 6"2" so my arm span is close to that and I pull 4 arm span lengths off the spool each time so I'm putting...
-
Cycledude reacted to BigBlue1's post in the thread Sthil Commercial Line Trimmers with 4 Cycle engines (still require 50:1 fuel/oil mix) - any experience with Good Post.
The manual for my auto cut head says it should take 7m (23') of .105 line per strand but there's no way that much fits. I do about half...
-
I went down to 16psi in the rears (noticeably better than the 24psi the dealer put in after adding the RimGuard) and even with the wood...
-
I've had this feature on every CUT I've owned, but they were all Deere, so maybe it's just a Deere thing. I honestly thought all...