corner bye's latest activity

update, I found the location of the snap ring. It belongs to the PTO shaft and keeps the clutch cam in place. I think with the snap ring...

Pics

I've made the repairs to the engine interface plate hardware and crank shaft bearing cover, with new seals and hardware. view"ck20...

Did you solve your problem?

the bolt was a clean break and I suspect that it had been broke a while, there doesn't appear to be any metal fragments under the cover...

I know, right. WTF

Picture of broken main bearing cover bolt

Update. As it turns out all of the interface plate bolts were not tight and the main bearing cover bolts were loose as well and one was...

Here is some reading on that issue with other older TYM/Kioti/Daedong tractors. I'm about to have to go through the same thing on my...

That's an interesting read, thanks for the post

There was no tell tale signs of a previous disassemble but you never know.

There were 3 bolts loose total. Shouldn't those bolts have loctite on them? I'm going to keep researching the snap ring issue. One major...

Bottom couple of bolts ground down

Update, as it turns out the clutch, pressure plate and throw-out bearing are in decant shape. The fingers on the pressure plate are a...

It doesn't feel like a slave cylinder setup, But I will be sure to check that when I get into it. I'm just lining up my ducks so that I...