Recent content by CHARLES W FLORENCE

  1. C

    JD 5205 screen removal for hydraulic pump Screen filter

    Thanks for your advice. I was able to successfully remove the hydraulic screen filter for JD 5205. My filter was stuck in housing so I used 2 screwdrivers to get inside the filter housing to push in the sides of the old hydraulic screen and then holding pressure on the screwdrivers pull the...
  2. C

    pantoprazole 40 mg oral delayed release tablet Tools needed to remover screen . two screw...

    pantoprazole 40 mg oral delayed release tablet Tools needed to remover screen . two screw drivers.See photo
  3. C

    What is a test for Steering rams mid seal failure?

    Thanks . Your explanation sounds like its on the right track. I have a photo of the filter and it appears to be open on both ends. If the crud is holding it because it is stuck I might try something, maybe a liquid , to break it free. If it is open on the far end, and I believe it is, I might...
  4. C

    What is a test for Steering rams mid seal failure?

    Thank you for your response. I appreciate it. I will defiantly follow your advice . I hope I can get the screen out. I cannot understand what might be holding it. I wish I could get some idea of what will happen if I keep pulling on it. Could the end break off? This is really a worry . I have...
  5. C

    What is a test for Steering rams mid seal failure?

    Thanks , I will probably have to take it somewhere. I have hoped to avoid that as it is quite expensive and I like to try and solve problems myself. I am puzzled what could be holding the screen in .It will move about one half inches as it would come out but stops. I have twisted it and pulled...
  6. C

    What is a test for Steering rams mid seal failure?

    Yes it does have a screen. I have tried to remove it, but it will not budge. I talked with the J. Deere Dealer tech. and he assured me it could be removed. I put so much pressure on it that I was worried that it would break. I decided that I should not continue . I looked it over as best I could...
  7. C

    What is a test for Steering rams mid seal failure?

    Yes it does have a screen. I have tried to remove it, but it will not budge. I talked with the J. Deere Dealer tech. and he assured me it could be removed. I put so much pressure on it that I was worried that it would break. I decided that I should not continue . I looked it over as best I...
  8. C

    What is a test for Steering rams mid seal failure?

    Thanks for your responses . I have now changed the filter and hoped that might be the problem. However, even though this stoped the problem until the tractor and bush hog were used about an hour . The bush hog stated to drag down after the tractor wormed up. I am puzzled that this will only...
  9. C

    What is a test for Steering rams mid seal failure?

    Thanks for your responses . I have now changed the filter and hoped that might be the problem. However, even though this stoped the problem until the tractor and bush hog were used about an hour . The bush hog stated to drag down after the tractor wormed up. I am puzzled that this will only...
  10. C

    What is a test for Steering rams mid seal failure?

    Thanks for your responses . I have now changed the filter and hoped that might be the problem. However, even though this stoped the problem until the tractor and bush hog were used about an hour . The bush hog stated to drag down after the tractor wormed up. I am puzzled that this will only...
  11. C

    What is a test for Steering rams mid seal failure?

    My steering wheel has a jerking motion as if low on fluid , but the fluid level is good . Could this possibly be that the internal seal on the ram rod has failed and letting the fluid bypass the seal? How could I check is that is the problem? Thanks Charles W Florence
  12. C

    John Deere 5205 pump problem

    My tractor is a 2000 5205 John Deere.The fuse of the solenoid fuel pump keeps bowing I am told the advanced fuel sensor causes this and if it is replaced this will solve the problem or you can disconnect it. The reason I have not just disconnected the sensor is that I cannot locate a sensor on...
Top