Recent content by CANMAR

I have a Yanmar RS1202 tiller I had to dismantle because the PTO gearbox cracked during shipping to US.I have tine shaft gearbox and alot of hardware still.Sold tines and gears from PTO gearbox.Ok4today@outlook.com

New Holland Dealer Parts on the internet shows the mid mount looking the same but has a before/after date change with the two part numbers.Here are pics of the two mounts that a found on the internet:

Thanks allot for your reply guyw,that info is what I was hoping to find.I seen a 7106 loader with mount that sold on the internet from a NH 1215.The mid mount looked just like another that I seen from a TC21.If your diagram shows them looking the same but having different part numbers,could be...

I just bought this New Holland TC21 after previously owning a Ford 1210.It sure is more modern,seems easier to operate but allot like the Ford 1210 in size.It has 1250hrs,in good condition and it even starts easily now after replacing glow plugs.I am planning to install a brand new Bush Hog...

Here are some pictures

Thanks for your comment teg,it seems like a kick butt tractor already with everything not even together yet. As far as comparing this tractor to a skid steer it seemed to lose a few more advantages to a skid steer.The loader controls are very fast like a skidsteer,I won't be able to load dirt or...

I am ready to mount the loader on the tractor tomorrow.It sure makes hooking up the hydraulics easy when everything comes with the loader,and you do not have to hunt for parts and piece together,like I have done before.I installed new radiator hoses and the hose that joins the hydraulic return...

I bolted on the refabed loader mounts and success,so far.

Thanks for your posts,I measured the frame on my CC8454 and it is 49" from the rear bolt on the mount to the front of the frame.I did not think about adding to the rear of the mounts to gain clearance for the loader at the front of the tractor. So DK35vince has a measurment of 42-1/2" and I have...

Thanks for your reply airbiscuit,I found that the cross member for the loader mount,that bolts to both sides of the loader mount from underneath fits with the mounts bolted to the tractor.So the width is correct at the loader mounts rear bolt location,so the frame of the CC8354 and CC8454 is the...

I started in on the loader install,weather here has been lousy this spring.I had time for more research between the CC8354 and CC8454 and have been lucky so far.The loader side mount's rear holes do line up with CC8454 even though mount is made for the CC8354.I am thinking both the CC8354 and...

I found on a diagram of the Kioti DK35 that the loader mount holes for the loader mount are not on the bell housing.They are on a section of the rear of the engine.

Here is a pic that should explain better about having to refab the front part of the loader mount.The rear part actually does line up with the four holes,two on top that you can not see and the two on the bottom.I seen have pics online where the Kioti DK45 instead of having the 7/8" thick bar...

Here is a diagram of the loader mount I have that fits Cub Cadet 8354 and Kioti DK35.

Here is a diagram of the loader mount of the Kioti KL1470 loader that would fit my tractor,a Cub Cadet 8454.