Recent content by canadianstrom

GATOR® G6™ BLADE, 18-5/8" Part# 396-748 I've had the same issues with the kubota mulching kit and blades doing an uneven cut and leaving the windrow of cuttings. I swapped in the Gator blades ( With plastic baffle still installed) and its given the best cut in 15 years of owning this over...

GATOR® G6™ BLADE, 18-5/8" Part# 396-748 I've had the same issues with the kubota mulching kit and blades doing an uneven cut and leaving the windrow of cuttings. I swapped in the Gator blades and its given the best cut in 15 years of owning this over priced, poorly engineered pumpkin. Just...

I have chains on my rear tires and use a quick pump of a brake pedal to manage direction when on ice

My tillage experience would lead me to believe disc angle would not help. I know of some people have sharpened the disc. Some crop residue could be managed by flattening and uniform angle to help tillage tool cut. But in this case , cutting residue better first would be most effective. Get...

My kioti 4510DSH with a 7ft lucknow blower, chains on the rear, homemade cab and a 8ft box scraper mounted to the frame of my forks . It has double edge and I put the rippers on shallow to deal with ice on the gravel lane. The box scraper makes it great to scrape back from my 2X 16' garage doors...

The vinyl is attached with clear twosided tape. Along the sides and back the roof had a ridge that gave a vertical edge that was convenient to work with. i figured it would hold it in place so I could come up with a permanent solution but its holding so well, It may be my permanent solution...

Just thought I would share, I got a roof from a golf cart, welded receiving brackets for the uprights and bolted to Loader frame and ROPS. Made uprights of 1x1 1/4" tube. Bought marine grade vinyl, which wouldn't last if the unit was stored outside. If it does start to crack at corners etc I'll...

Good Day I have a GR2110 with about 300 hours with a couple of intermittant issues. 1 sometimes the starter just clicks, either try again, or release and reapply brake or tap starter and it fires right up 2 sometimes after several seconds after getting off running machine ( blades off) at low...

I am having a hard time removing the HST Oils strainer and the Boss that holds it in. Any tips appreciated.

I have been bothered by a the clutch ds4510 HS . While releasing it at high rpms, in reverse and backing up a hill , I get some crazy jumping of the clutch. It is like it goes from from a nice easing into motion to full speed then back to no engaement of the clutch, repeat untill I am cursing...

I went to the garage this morning and heard clicking, fairly loud, every couple of seconds, tracked it down to the ignition of the kioti ds4510hs. I removed key , still kept doing it. I pulled the posititve battery terminal and it stopped. I am assuming this is another bad ignition switch (...

Hello I have a Kioti DS 4510 HST- loving it except that you can't use the radiator fan blades as a wood chipper ( backing up in the bush, rear tire went over the end of a stick, it rose up into the lower radiator). Replacing the blade yesterday, I saw a cut rubber line, it comes from the top of...