Finally made time to finish this weight project. I will need the ballast this spring. turned out nice. the weights are family farm items. they were given to me from my late Dad. he would get a kick out of this use. there is no liquid ballast in these tires. I don't want any as I mow with this...
I was looking at a tractor without a mid PTO. I asked a dealer if it was available, and it was. I could install or they would. this was 1-1/2 yrs ago. deal fell thru. but check to be sure of availability. good luck. Nice tractors. I have bought a similar Case/Farmall 35 and really like it.
My new wheel weight project is getting started. these are from my Grandpa's A. and I last used them on my old 234 IH mower. now adapting them on my 35.
I had a bit of time to get this under way. here is a weight I'm going to use, and the Barbell weight marked. BB weight will be drilled for both (4) bolt OE Farmall weight pattern and the (3) bolt OE tractor wheel pattern. acting as the adaptor. these weights were adapted to my older 234. and I...
tractor has been working very well for me. made this trailer mover. and added pallet forks. making rear wheel weight adaptors next using my Farmall A weights.
I'm going to make rear wheel weight adaptors for my tractor. I'm using bar bell weights to adapt the A Farmall weights. I had these A Farmall rear weights on my 234 IH, and the bolt pattern is now different on my 2008 Farmall 35.
It has been a busy summer. Tractor is working well and mowing has been cut down to 1 Hr. ish . I did get a set of forks. and they work very well! I will say this rear discharge deck is a really slick. very clean.
I sent you a message. can this kit be used to add a second rear valve on my Farmall 35 mine is a 2008 model. I have a OE single rear now! want to add a the second valve.
as promised. thou not painted yet. I really like it. took a bit to decide on how I wanted the lower pins. and welded the cat3 pin nuts right in the lower tubbing. just had to grind 2 of the points down on the hex nut. worked nice! I have to [paint it. but I wanted to add chain hooks to the 90...
I have wanted to finish this trailer mover and now I have almost all the pieces to finish this. should be done this week end. want it to move my car trailer when mowing. built by inventory. but with new pins.
I am very pleased with it so far. I really like the treadle petal on this 2008 Farmall 35. and the cruise, I mow steep hills and the power is great with the 72R deck. also I have used the loader on a couple projects. and it works great. I have bought FL tines for the loader as well now. I had...
thanks, looking forward to spring. I store the loader in my cold side of my shop. and the mower in my house garage. no room for it complete. very impressed, the loader is very easy to remove. under 5 mins and it was my first time doing this.