Recent content by Beaver Cove Deere

Just search extrusion plastic. I’d start with McMaster Carr. I replaced one thru the factory for my old blower.

Not something I’d run to JD for. Too many aftermarket options.

I’m being overrun by red squirrels so I just got 2 5 gallon bucket trap lids and declaring war.

I’d buy a AGM battery and call it done. I’m sure a lithium battery ain’t cheap.

My machine at work was a 12x12 clutch no power reversal. 56 PTO HP My personal machine is a hydro also 56 PTO HP. I don’t miss the 12x12.

Much easier to back up the trailer with the axels to the rear is another benefit. 10% tongue weight minimum.

I’d buy another Normand inverted tomorrow if mine was destroyed today.

They suck to plow with. Need at a minimum a 9’ plow for a standard cab and chassis. DRW float on top of the snow thus not getting the traction down to the ground. Drop a yard or two of salt and sand into the dump body was one way around it. In the old days you would see one set of tires removed...

The weight is what helps in scraping up packed snow and ice. I’m doing a neighbors paved drive temporarily while he is recovering but my blower is set for my gravel drive that is still setting up a base. What a beast on pavement this could be with a simple adjustment.

Ex Lax wasn’t moving this clog. Rain and warm helped along with an irrigation trench shovel. Next in the arsenal was a salamander heater and calcium chloride. 😂

Mine has proven itself several times and as recently as early last week. It clogged up because I did something very stupid to try. 😂 We had 11 inches that was compressed to 8 with major rain. My inverted did just fine other than attempting to recycle snow from 3 full passes at a sick...

I wouldn’t blow with the UTV. Not enough power by a lot.

Thank you.

Does anybody know the hours a dealer is billing this timing cover repair?

The tread pattern clearly says they ain’t R-1 or 4. They are not turfs so what’s left? Fact is I like them for what surfaces I want to use the machine on.