Recent content by Bayfisher

Hello Renze, is there a coarse radiator for replacement in a 5211, my rad looks to be a fine mazed original and repaired many times, so if replacing it i would rather have the coarse.

rest ur feet on the floorboard and look down, its a cap with a slot in it, chk with engine off.

ggle and tube are rewarding these fools to bring traffic to their site, many good posters have left them, it makes honest hard working folks look very bad, and their trade.

are u sure the HNL range selector isnt being bumped when boarding/unboarding or during operation of the tractor, look at all the detent valves and springs on top plate, u may have to pull top plate off and look for worn damage inside, is the trans fluid contaminated/milky looking.

location of bleeder on 5211, with black cap behind lever, red arrow, and follow above procedure.

do you have the manuals [ service and parts ] ? if the tractor is in canada then the oil is incorrect for the climate. being that u installed new sleeves and pistons the engine will need to be broke-in before u get good compression #s, recheck the valve clearance as they may not be completely...

it should be npt [ national pipe thread ], found at any hardware store pipe/plumbing.

ive had to down several tree's, used it to clean up limbs, logs and debris, leaves, and smooth out several area's where fence post was removed, limbs and trunks up to @ 30" dia cut to manageable lengths and never broke a tine, my yard has many above ground tree roots to catch the tines but...

wouldn't expect anyone there to know, but its a good day for a road trip.

ive got the 7ft rake from TS and quite happy with, it hasn't broke yet, although some say i am trying.

very happy i dug thru the net and utube before i made a tractor decision, mine came in rough condition but am impressed with the way its overbuilt. they are a very impressive brand.

Not yet steve, rented the slide hammer and returned it before i smashed a finger :). but did try it, so am making a puller so i can do all three and keep all my fingers.

The forum has a Zetor section. check with brent or david @ ridgeway tractor parts https://ridgewaytractorparts.com/

no i haven't, only calls.

yep on ridgeway, good folks over there.