Recent content by Atypical_decorum

You eouldnt happen to have more information on what I need fo ya? For the power, I use it mostly for puttong stuff, chicken tractor, downed trees, and mowing. I put shorter tires (L3 trenchers) on it to regain some torque which has worked wonderfully. I very rarely go over a slow walking...

Im more than willing to return it. I do like a single wire setup though. Dont have a lot of time for this project.

The one I found just now is the "Kubota #B7324 40 Amp High Capacity Alternator Kit." Gonna look it up now. Update. I looked it up. Looks like a lot of freaking work to put in. I was annoyed with just a bracket.

Well, to avoid necrothreading Ive made a new post aboit this. I know there was a similar post about 5-8 years ago, but I can't find it. My 2004 kubota B7500 dyno has finally bit the dust. 20 years and 1600 hours later - not bad if you ask me. But now I need a new one. Ive seen 10si...

Ha, it's for when Im using the moonraker.

But there's a possibility to use laser beams!!

That kind of speed is hard to get via GPS without some seriously expensive equiptment. Something touching the ground is the best way or maybe... Laser beams! When you see the tire of a tractor at 0.1mph moving, it's painfully slow. The front tire is at probably about 0.04rpm if it's a 46" tire.

I didn't know if this tractor fell into the ag catagory that runs 30k hours. But I'll pass if it's in the utility catagory where 10k hours is about it.

How good is this tractor? It has 8900hrs, got a new transmission 1000hrs ago along with a rebuilt engine. The main articulation point has been replaced at the same time. It's got the loader and cab end 3pt. The guy offered it to me for 27.5k. No other problems that I know of.

That's true. I've seen several versions now. The three most common I've seen are 1mph, 1.7mph, and just over 2mph at 2krpm. I suppose it could actually be 0.05mph. That M9960 I had did have a creeper gear and did about 0.13ish mph at 2krpm. On smaller tires, that could be less for sure. The...

I got ya. I didn't know those TLBs had a 3pt/pto.

I had chatgpt do the math. From a 71" tire to a 51", 1mph drops to about 0.75mph. I have to see what the height is on a standard M5 v LP to get the right calculation.

It seems like so many posts on here get derailed by a few people. Does anyone have input back on the initial post?

Ok

I had to take you off ignore to see this. They didn't have counter weights. Just ballasted duals and scrapers.