Recent content by 1700E Dreamer

Have a 4 post 9000 lb Wildfire Same size shop I roll it into the corner in the winter for storage then back in front of the door for servicing the truck in the summer Yes 2 post are better for servicing But no worries about cars falling of Don’t need to bend over to place the lift points then...

I have the same model and it does this regeneration about every 4-5 hours I let it run ( outside)at 2-2500 rpms until it’s done. Takes About 30 minutes Sort of a pain in the backside but we can’t change it

I have a similar set up and added a 1.5”-2” x 7’ scrap steel pipe with a 1/2” slit length wise Hammered it on the blade it’s a tight friction fit and now the plow doesn’t dig in Because of the round edge Very happy with the results And it didn’t cost to much but time

That’s funny

Looks good

I will lower the pressure to 18-20 PSI

Yes your correct . I will lower the pressure to 18-20 PSI

I thought about that

yes you are correct. I will lower the pressure to 18-20 PSi

Just for your information. Massey 1700e series (2017), loaded with beet juice, Titan tires, My tires were spinning on the rims, it took a while to figure out , until I looked over the edge and watched it spin, both sides, could'nt figure out why it had trouble moving going up hill, on the...

I have the Massey 1738E , hydro, quick disconnect bucket / forks , 4X4 with R4 tires, purchased in 2014, has about 400 hrs on it now, no issues so far, love it , could always use more power , but that's a guy thing. It does not have the extra hydraulics lines ,( front or back )you will need...