LS Tractor Owner
Super Member
- Joined
- May 1, 2017
- Messages
- 7,562
- Location
- Edgewood, NM
- Tractor
- LS XG3025 TLB, Previously MT125 TLB, Craftsman GTS6500
Good morning to all! Low of 23, going up to 46 today... last day of warmer temps. Tomorrow's high expected to be only 35 and windy. Maybe a few flurries.
Drew, excellent philosophy!.... happiness is within us all, just a matter of finding it and letting it out!
Popgadget, nice progress on the speaker boxes.
I was able to start on the table saw restoration yesterday after making a run for some materials. Apparently I had used up all of my "rust restore" paint. I was going to do the underside of the cast iron top, that doesn't need to be perfect. I will sand and polish the topside. Surprised that I found a drive belt in stock for $10. A new 220v plug was needed, man did they get pricey! ... the cheapest I could find was $18.
RNG, no, not a Delta.... I wish!.... It is a Shopcraft Commercial saw, made by the Benchmark Tool Co. in Missouri. They are out of business, but surprisingly, I just saw a few of these saws up for auction....
Here is a few "before" pics. Hopefully, I will have some "after" pics tomorrow.....



I can't remember if I posted the pic of the trinket box for my grandson after it was finished..... too lazy to look back... so here are a couple of pics....



Wifey is baking cookies, so time for me to get out of her way! I'll check on her later and do some QI :licking::thumbsup:
Everyone have a great day!
Drew, excellent philosophy!.... happiness is within us all, just a matter of finding it and letting it out!
Popgadget, nice progress on the speaker boxes.
I was able to start on the table saw restoration yesterday after making a run for some materials. Apparently I had used up all of my "rust restore" paint. I was going to do the underside of the cast iron top, that doesn't need to be perfect. I will sand and polish the topside. Surprised that I found a drive belt in stock for $10. A new 220v plug was needed, man did they get pricey! ... the cheapest I could find was $18.
RNG, no, not a Delta.... I wish!.... It is a Shopcraft Commercial saw, made by the Benchmark Tool Co. in Missouri. They are out of business, but surprisingly, I just saw a few of these saws up for auction....
Here is a few "before" pics. Hopefully, I will have some "after" pics tomorrow.....



I can't remember if I posted the pic of the trinket box for my grandson after it was finished..... too lazy to look back... so here are a couple of pics....



Wifey is baking cookies, so time for me to get out of her way! I'll check on her later and do some QI :licking::thumbsup:
Everyone have a great day!