50F and mostly cloudy @ 05:15.
Amazon did deliver on the butyl tape and jigsaw blade for the cement board - just not early enough to do any cutting. I did get the cement board moved around back onto the sawhorses. Will need to move that inside here in a bit, as rain is headed in.
The Woman's stuff is due in today, along with the aluminum tile flange.
Moved old stove out of kitchen onto to a pallet and got it moved over to the barn, had to remove door from hallway into kitchen to get it out. Hinge pins came out a lot easier this time around (I lubed them when I took it off to bring the new stove in ... :thumbsup
Brought roll of 6 mil visqueen over to the house from the barn and rolled it out and cut off a piece to use to line the shower under the backer board then took it back on next load. Snagged a fairly straight 2 x 4 to replace one in the shower wall that is badly twisted at the bottom.
Also got MMM moved over to the barn and put away, along with longest water hose, a roll of geo grid and some scrap metal.
Another 4 bucketloads of crusher run added to upper driveway and more or less spread out. Needs more fine-tuning though.
Set another rebar on the corner up by the shed to keep
somebody from cutting the corner and driving on my lawn ... need to check and make sure I brought the sledgehammer back down ...
Cleared the leaves that had accumulated around the front of the house with the Stihl blower.
Have a fairly regular momentary loss of power in the circuit that feeds the kitchen lights and wall outlets in the living room ... hopefully just a breaker going bad. High priority on figuring out what is going on with that.
Major item on agenda for today is to get old toilet emptied and pulled.
Hope everyone has an enjoyable, productive, and safe Saturday ... :thumbsup:
