I have a JD x729 and have lots of sports bottles that just don't fit the cupholder right. It's narrower at the bottom, and when I swing around turns, my bottles seem like they're going to fly out...
I had a rear pto installed by a dealer for my x730
They didn't properly vent the PTO assembly, so the oil wasn't properly circulated.
Watch this video.
I dodged a real bullet, once I vented...
J D site is giving me the run-around . I ask the question "does the X700 have liquid cooling ?" They immediately take me to some other Mod . X 7 - - and never state if the X700 is air or water...
I have a x-700 with just over 500 hours on it, I can be mowing along and it just quits, but it does start right back up, if I feather the choke, sometimes I can keep it going, other times it still...
I just purchased a used X734 to replace my Kubota G4200H. I'll sometimes use my LT to store and extract my trailer from my back yard, especially when the ground is wet and I don't want to drive a...
I went back a couple pages and didn't see anything posted. While on JD's website, I see certain models like the X739 listed as 2018 only. There were a few others as well. Is there a redesign...
Good morning,
A quick question. Is anyone running a PTO generator on their x700 series, particularly the diesel? I'd like to know your comments on performance. Does it hold the loads fairly...
Has anyone adjusted the slide rails for the JD739 seat. The owners manual says to remove the four bolts connecting the rails to the tractor body. But, since you cannot see the underside of where...
The X734/54 have narrower tires than the rest of the X700 series including the X739 which is also AWS and has the wider tires. Does anyone know why? Can the wider tires be put on the X734/54?
Hi all,
I'm new to this forum. I've actually used this website forum for research over the last couple of years - mainly to troubleshoot my JD L130 transmission problems. Last year, my L130...
Has anyone made the JD front fender kit fit on a X734 AWS? I see JD says it only fits the 2 wheel steer models. I'm wondering how or what might be needed to make them fit as I HATE seeing the...
Hi guys Im new to this forum, wondering if anyone has seen an implement like this. I now have a J.D. dethacher on my 265 lawn tractor with the hand pull to lift. I rake up sticks in my yard into...
Just got finished building a house last fall. Our old house was on property in town and I could cut everything with my push mower in about an hour and a half so I never purchased a rider. Our new...
Anyone that use to have an X700 Ultimate vintage 2006-2012 trade in for a new 2013 X700 series? If so what are the noticeable differences after using it?
I have a 2012 X740. My hydraulic system is 924 PSI at 4.5 GPM. Does my tractor have enough hydraulic power to use this hydraulic cart?
Cub Cadet Parts
I am concerned that if I splurge and buy...
Question is in relation to a 2013 x738 and others that function the same way. X738 4 WD, If the right front wheel is spinning such as being stuck in the mudd, Should the Left front engage and if...
Do any of you guys have a 3 point on your X series tractor? I've had a 3 point on my X748 since it was new 7 years ago. I don't use it much, but I do have a 647 tiller, a disk, and a sprayer. I've...
Has anyone ever done this?
I wanted to add a work light to the rear fender of my 2012 X740 to shed some light behind me when working in the dark.
I went to my dealership on the weekend to order...
I know this is obviously too late, as I have already purchased my X740 with the 54 inch deck. However, I am wondering if all the claims about poor cut quality are true?
How would gator blades be...
There has been a lot of speculation as to whether the decks for the new 2013 x7's will fit the prior models or not. It is reasonable to assume that they will since the wheelbase has not changed...
Guys,
Just out of curiosity, who makes the 4WD steerable axle on the X700? Is it Tuff Torq or JD? I see that the X700 is using the Tuff Torq K92 Transaxle, so I was wondering if the steerable...
I was expecting a bit more than this short teaser but it's better than nothing. I searched the forum and didn't find this, sorry if it's a repost.
X700 Signature Series Mower Deck
X700 Signature...
Guys,
I am currently in the market for a new John Deere X700 series tractor with a 7-Iron mowing deck. I am only going to use this tractor for mowing the farm and nothing else, much like any...
Hi Guys,
I have a JD 4520 and Scag TigerCat to maintain the family farm. I live about 400 miles away but I try to get up there every one to two months to do as many chores as I can. Of course...
John Deere is now offering $1,000 off the price of new X700 series machines.
Last I heard, the new X700 series will be officially revealed next month in February, so it makes sense they are...
The title says it. I maybe be selling my john deere 455 with the 54 inch snow blade and hydraulic quick hitch and angling setup. Has anyone bought a new one recently? I am wondering what the...
I'm interested in seeing an X700 series tractor, especially a diesel model, in the Atlanta area. But, I can't seem to find a single dealer that stocks them. There are lots of Deere dealers around...
So, has everyone seen the new X700 series machines?
Scroll down a little more than half-way for photos:
http://www.mytractorforum.com/showthread.php?t=250573&page=9
At first I didn't like it...
Hi Folks,
Is there a matrix somewhere that can help me navigate the 2010-2013 MY changes? I am not talking about small options, colors, etc. but rather substantive mechanical differences, if...
I know it it a garden tractor with limited ability with its FEL but there is a company ANBO and it makes grappler/ loaders for subcompacts- could I use this on lets say an x720???
How difficult is it to remove and re-install the 7-Iron mower on a X700 series tractor? Can the gauge wheels be turned sidewise and the mower deck rolled out from under the tractor? I am still...
Our X720 seems to be burning better than a gallon and hour, more like 1.5 gallons/hour. We can get about 5-6 hours of mowing time out of a full tank. To us that seems like a lot. Is this about...
Just about settled on buying an x500. Just wonder what I can do with it besides mow. Can I pull a plow, tiller, etc? Wondering if I should bite the bullet and by an x700, but by the time I outfit...
Is there a way to hang a 25 gallon sprayer on the back of the X700 series besides getting the 3ph? I have used my old sprayer in the cart, but I want to put a new sprayer right on the back...
So I have wondered this for a while, what is everyone opinion on 2 wheel steer tractors vs AWS tractors? Here in WV it is hard to find a flat spot, so the majority of our mowing is on hills. We...
All - I picked up my new X749 today and had ordered the AM134625 flow control valve to prevent deck travel when using my JBSr. I cannot seem to locate any installation instructions. I do see...
Looking at a used 2007 JD X700 w/ 54" deck. Found it on craigs. 325 hrs. Very good cond. $5850. Are these gas or diesel? Shaft or belt drive? Does the 54" deck cut smooth, even and scatter grass...
Does anyone 'truly' know what the 3 point hitch lift rating is for the X700 series (can quote scripture)? I can't find anything from Deere's site, and all posts talk vaguely of '..it's about x...
Just picked up a used 2010 X700 and the fuel gauge is not working. I don't have a dealer real close to me so I was hoping to try to find out what it is and have them send me the part. When you...
With the new "1" series Sub-compact tractors introduced, I am thinking that the X700, X500 and X300 series are likely soon to be updated? Has anyone heard anything about a replacement series for...
Does any one have any pics of the inside of a John deere x728 hard side cab and of the switchs to operate the windshield wiper and the button to turn the heat on.
My wife says she may sell the X720 and get a BX 1860 or 2360. She's really not too happy with the JD, been in the shop once already and drinks gas like no tomorrow. I tried my best to get her to...
I know this question has arisen many times before, but in my search for a 4000 series unit, I have been searching for a riding mower as well.
Now, I would like to hear from people on the famous...
I sat on a Kubota BX last night, and was surprised to find that with my more limited right leg mobility these days moving my leg from the forward to reverse pedal on the hydro was an issue. I...
i was using the tractor the other day with the tractor shovel and got hung up on a tree stub i was moving.the tractor was on a pretty good incline and justshut down. i checked fuel which was 3/4...
Hi all,
I am looking for a first tractor for a new proprerty of about 10 acres, with 3 acres to regularly mow. The property is in great shape and I am looking for a mower (which is what I will...
I have been in the market for a new mower for a long time now but just have not made up my mind on what to get yet. Today I came across a 2007 X700 with 62 hours on it for 7K. It has a 48" deck...
First, I had a lead on a used JD 455 Diesel garden tractor that fell through.
Next, I was looking at an X700 that had 11 hours on it but I lost my company and Deere's rebates so new looks better...
Hello,
I have a x728 which is getting a 3 point hitch and box scraper in two weeks, I know its a limited category 1 hitch which after tons of research I find it can
mean its either a Cat. 0 (20...
Does anyone know if you can adapt the delux X700 seat to fit on the 2305? If so does anyone have a picture of the 2305 with the seat on it? I would like to see it and show it to my dealer. I...
Regarding Deere X700 series with Tuff Torque K92 transaxles, the Deere manual has this to say about the fluid:
"NOTE: Machine is filled with John Deere Low Viscosity HY-GARDョ (J20D) transmission...
Hi,
Am considering purchase of a Deere x500 or x700 series tractor. I'd appreciate hearing whether folks think all wheel steering is a big benefit (unfortunately, it looks like it only comes...
I'm considering a purchase of an x500 or x700 series and wonder if any of you have some input to share on their utility, value, and ground clearance. I am currently using a Craftsman...
I found this little tidbit on Deere's site today:
http://www.deere.com/en_US/govsales/purchaseguide/2006PG/TOC.pdf
ADDED IN EDIT:
Well the whole thing was there earlier, but now I can only get...