The throttle on my X324 will not stay where I set it, it creeps down until I notice that I am crawling along.
I took a quick look under the dash, the chock and throttle cables both go into a black...
So, I've been searching and reading and think what I want to do will work. However, I've only seen it listed twice in older threads and wanted to verify. I have a 2006 X324 with a cracked, beat up...
Hi I hope someone can help me I changed for fuel filler and I got spark to the spark plugs and the fuel pump is working ok I clean the carburetor
3 time and put it back on and still no start . oh...
I am in need of some help with my 2010 x324. About one-third of the lower rim of the clutch sheave broke off, resulting in a shredded primary drive belt (the day before leaving on vacation). I...
48" (non-rotatable wheel version) deck on an x324. ~10 years old and runs great. Bolt holding the right hand blade sheared off the other day and I had to replace the entire spindle/bearing...
I have my eye on this tractor to help speed up my mowing time. I have really too many hills to consider less than this tractor. But I am also still open to any other suggestions. I am hoping to...
Over two yrs, i have had a proplem when mowing. when cold pto engages intell it get warm. stop to dump grass. wont engage. cools down. will engage intell it gets warm, just put in a new jd clutch...
Yet another "help me buy" post. It seems the John Deere line is one of the better lines, but truthfully I'm not sure I've been able to find a good comparison source or webstie. So, I'm open to...
Hi All,
After searching for the best attachment for northeast fall leaf collection, we've finally settled on an MC519 cart for the back of our X324. We first tried a Cyclone Rake Commander, but...
I have decided to buy my brother either an x320 or x324 for his birthday. He has never been able to buy anything but the average $1000 mower and never owned an HST. After about 5 years, his...
I've narrowed my search down to the above tractors. I believe all would do the job I have of about 1.2-2 acres of bermuda grass with a few trees, obstacles. I would like the better powered one...
I'm ready to buy a mower and wonder if there's some real-world advise for deciding between these two... I have a tractor w/ FEL & brush hog, etc. to do snow clearing, etc. So the purpose of the...
I'm ready to buy a mower and wonder if there's some real-world advise for deciding between these two... I have a tractor w/ FEL & brush hog, etc. to do snow clearing, etc. So the purpose of the...
My wife and I have decided we need to upgrade our lawn mower. We are currently using a 4 year old JD L120 that has not held up well. We mow 2 acres at our house and a 2 acre cemetery down the...
Ok, I know the 324 has four wheel steering and according to their website goes a bit slower in forward (5.5 mph instead of 5.8mph). The question is, how crucial is this four wheel steering?
I...
:confused:
First of all - great, but dangerous forum. I haven't received any responses to this on the JD forum, so I figure I'll try this more general forum, as it applies to new vs used...
The X324 I bought a few months ago (12hrs on it) died on me today.
It was a hard start but finally started - blowing out some white and black smoke once it did start. Seemed to run okay after...
Were there any significant changes from 2007 to now for the X324 lawn tractor?
Dealer dropped mine off a couple days ago and I noticed it has a 4/07 build date. I bought new and the unit hasn't...
Just moved into a new place on 3.5 acres total - about 2 acres wooded and 1.5 acres newly laid sod. I don't have many obstacles to mow around, but I do have a couple of slopes to deal with and a...
I am new here. Live in SW IN, & mow 2 1/2 acres. I am going to buy either the cc 2550 or jd x324. As I decide, I have questions and comments.
How hard is the deck on the cc to remove and...
I've been shopping for a mower, and was just about ready to buy a leftover JD LX280 AWS, when this X324 (see attachment) showed up in my dealer's showroom. There were enough differences to change...