auzwrks
New member
Does any one have an idea of what is involved to change a clutch in a Zetor 7245?
Zetor 7245
- Thread starter auzwrks
- Start date
- Views: 7020
dieselknudt
Member
- Joined
- Aug 19, 2015
- Messages
- 41
- Location
- Upsala, MN
- Tractor
- IH 1086, Belarus 925, Farmall 300, Farmall M, Farmall H
They are a pretty standard split.
This tractor has a dual clutch with the PTO disc captured in the PPA so I would just replace both at the same time.
This tractor has a dual clutch with the PTO disc captured in the PPA so I would just replace both at the same time.
TBN Support
TBN Support
- Joined
- Feb 4, 2015
- Messages
- 4,560
Hi and welcome to the forum. :wave:
I'm going to move your thread on over to the Zetor section. Best of luck with that clutch!
I'm going to move your thread on over to the Zetor section. Best of luck with that clutch!
Be sure your master cylinders are not bad... most of the time with Zetor you just need a new master cylinder and a good purge of air to fix your problem.. iv rarely seen a zetor clutch actually burn up.. and been around them for a very long time
