Pearlsnaps
Member
Morning y'all.
I'm working on the dome lot to be activated with a door being opened. I took the dome light off and found that you can add a ground to the bottom pin of the dome light switch, and that will activate the dome light when the dome light is in the middle switch position. I took a lot of the push pins out of the ceiling to lower it down enough to run a wire over to the left side b pillar to add a door switch. You do have to drop the screws out of the radio mount in order to run a wire across the inside of the ceiling. I should have taken pictures, but I did not. Sorry about that.
I haven't had time to install my door switch and make a bracket that attaches to the lower hinge of the door and close onto the about to be added door switch.
Here is a picture of My findings on the dome light switch.
I'm working on the dome lot to be activated with a door being opened. I took the dome light off and found that you can add a ground to the bottom pin of the dome light switch, and that will activate the dome light when the dome light is in the middle switch position. I took a lot of the push pins out of the ceiling to lower it down enough to run a wire over to the left side b pillar to add a door switch. You do have to drop the screws out of the radio mount in order to run a wire across the inside of the ceiling. I should have taken pictures, but I did not. Sorry about that.
I haven't had time to install my door switch and make a bracket that attaches to the lower hinge of the door and close onto the about to be added door switch.
Here is a picture of My findings on the dome light switch.