When I replace panl

[Bvill01]

When I replace panel(keyless) start do need to reprogram or just install? Replacing it with keyless panel

 

[SSdoxie]

When installing or replacing a keyless panel all you need to do is press and hold the run enter button for about 5 seconds until it gives a beep and the panels light up. No need to re-enter the password(s) they are stored in the main controller.
Note: I should clarify, this is for a loader (skid or track). If it is an excavator or toolcat there are other procedures required.

 

[Bvill01]

Thank u all try that