Front-End Loader walk me thru unhooking a Kub FEL

[buckeyefarmer]

If taking the loader off in a dirt area, it helps to put a scrap piece of lumber under the stand so it won't sink into the ground. The key is a nice flat area.

 

[NuBota]

All good info - I have had the same basic experience. But one thing that slows me down - I'm REAL uptight about cleaning the QCs - is this overkill?

 

[Bird]

Overkill? I don't know, but one thing's for sure; it can't hurt. In my case, I always removed the FEL in the shop building so the air-compressor was handy. I wiped the male connections with a rag and gave the female connections a quick blast of compressed air before hooking back up if I saw any indication at all of dirt, dust, or other contamination.

 

[Window Geek]

I'll take some tomorrow and get 'em up here!
Edit: Just noticed it's after midnight so I guess that would be today instead of tomorrow!

Sir Charles, Good Doctor, AKA Chuck,
I know it's Father's Day and all, but would you snap a picture of that really nice FEL connector and post it? I've only got a little time left on the Father's Day wishlist.
Thanks,

Paul

 

[Glowplug]

Sir Charles, Good Doctor, AKA Chuck,
I know it's Father's Day and all, but would you snap a picture of that really nice FEL connector and post it? I've only got a little time left on the Father's Day wishlist.
Thanks,

Paul

Okay. It's been tough to get away from my girls this weekend. Not that I really want to. But I'll try to take care of it today!