mjncad
Super Member
Some of you may recall the water buffalo I built a couple of years back as documented in this thread. http://www.tractorbynet.com/forums/build-yourself/250246-my-most-ambitious-fab-project.html
Well I finally got around to doing the as-built computer modeling, drawings, and renderings as seen in the following images beginning at this point in the photo album, and going forward. https://picasaweb.google.com/110106108324823291002/WaterBuffalo#5785562415822273074
The original pre-fabrication drawings were done in AutoCAD, and the as-built modeling and drawings was done in Inventor with the renderings done in 3DS MAX.
Well I finally got around to doing the as-built computer modeling, drawings, and renderings as seen in the following images beginning at this point in the photo album, and going forward. https://picasaweb.google.com/110106108324823291002/WaterBuffalo#5785562415822273074
The original pre-fabrication drawings were done in AutoCAD, and the as-built modeling and drawings was done in Inventor with the renderings done in 3DS MAX.
