Tym T394 Jerk Fitting Size

[allstar45]

What is the Zerk grease fitting size on a TYM T394 tractor so I can by a tip for my grease gun to fit?

 

[jigs_n_fixtures]

To the best of my knowledge there is one standardized size for Zerk fittings, available in a bunch of different thread patterns.

I have this kit and haven't found any that it doesn't handle.

https://www.amazon.com/dp/B07H9HMBPX?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2

The other thing you want is locking a coupler on your gun.

I have these: https://www.amazon.com/dp/B0BB6FTT6N?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1

 

[steve tym]

Agreed

 

[TractorTYMe]

Some claim threads are BSP (British Standard Pipe) or metric. The confusion is still a fact on that one.

 

[jigs_n_fixtures]

Some claim threads are BSP (British Standard Pipe) or metric. The confusion is still a fact on that one.

I'm betting on metric. I had to pull a broken Zerk's fitting on my FEL. I have kits of both metric, and ASE fittings. The threads on the one I pulled out, matched the thread on the 6mm metric fittings in my kit.

I have never seen a BSP Zerk's fitting. Just checked Grainger, and they list metric fine thread, SAE, and 1/8 and 1/4 pipe thread, and a couple of self-threading taper thread versions. But none in BSP.

 

[ptsg]

Some are 1/8 BSPT fittings, other may be M6 like the ones on the tie rods and front axle pivot points.