2005 CC RZT 50 with about 195 hours.
Am replacing the engine, dropped a valve (B&S 22 Intek).
Noticed something new... oil on the floor. Found the line from the reservoir was cracked, and all the oil drained out on the floor. Did not drive it that way, it happened near when I pulled in in to pull the engine. I am replacing both lines.
1. How do I drain the trannies?
2. According to the manual, I can use a good 20-50 oil, the CC tech says they use a 20-50 syn-blend.
3. To refill, I guess I add a little at a time, with the wheels in the air, and slowly operate it F and R to get out any bubbles?
Thanks in advance!
Am replacing the engine, dropped a valve (B&S 22 Intek).
Noticed something new... oil on the floor. Found the line from the reservoir was cracked, and all the oil drained out on the floor. Did not drive it that way, it happened near when I pulled in in to pull the engine. I am replacing both lines.
1. How do I drain the trannies?
2. According to the manual, I can use a good 20-50 oil, the CC tech says they use a 20-50 syn-blend.
3. To refill, I guess I add a little at a time, with the wheels in the air, and slowly operate it F and R to get out any bubbles?
Thanks in advance!