This is on my land trac 250 DTC Long agribusiness. The Montana is the replacement of my Koren model.
I was running the brush hog and I went over a tree that was a little too big and it bound up the blades and stopped everything. I thought it would have broke the sheer pin but it didn't. I immediately went to start it back up and there was nothing. No crank, no noise from the starter anything. I thought it was the negative ground and found it was loose. I replaced the negative cable and still nothing. I checked that the engine is not locked up. I got the tree out from the blades and spun the PTO shaft. I still don't have any crank. I do get power to the dash and to the PTO switch but nothing when I try and start it.
I was running the brush hog and I went over a tree that was a little too big and it bound up the blades and stopped everything. I thought it would have broke the sheer pin but it didn't. I immediately went to start it back up and there was nothing. No crank, no noise from the starter anything. I thought it was the negative ground and found it was loose. I replaced the negative cable and still nothing. I checked that the engine is not locked up. I got the tree out from the blades and spun the PTO shaft. I still don't have any crank. I do get power to the dash and to the PTO switch but nothing when I try and start it.
