help, while talking of the zforce 44, i have removed my belt and deck for cleanup and install of new blades, now when i put it all back together and pull the tensioner rod to tighten the belt, the pulley is allowed too far over and therefore the belt is rubbing itself. i do not remember seeing the tensioner spring so stretched, what am i doing wrong?
tension for belt
- Thread starter celtic
- Start date
- Views: 1331
JimR
Elite Member
Sounds like the belt is too short. Did you match them up?
Bob_Bainbridge
Platinum Member
Assuming you are still using the same belt, it sounds like you have the belt installed wrong. There's probably a different route it can take. Been there - done that!
Bob B.
Bob B.
