dieselscout80
Elite Member
Today I went to use TC45DA and its 250TL loader. The loader went up fine and lifted a log splitter without issue, but wouldn’t lower the load when the joystick was pushed into the lower position.
However, when I pushed joystick into the float position it lower as I would expect it to.
I checked and none of the loader couplers are loose.
Does anyone have any ideas or suggestions on how to proceed?
However, when I pushed joystick into the float position it lower as I would expect it to.
I checked and none of the loader couplers are loose.
Does anyone have any ideas or suggestions on how to proceed?
