runaway trailer

[257NH]

I was going to chappell tractor today and got into a bit of a traffic jam.When I got up to the cause I snapped a phone pic,
http://i147.photobucket.com/albums/r287/257nh/0428081347a.jpg
I didn't even see the tow vehicle but when I got past it I looked back and there was a kubota still chained to the trailer.

 

[groundcover]

I saw one Sat. in Keene,looked like the trailer didn't make the turn at the lights at 101 and Rte. 9. The roller was still chained to the trailer but on the other side of the road from the truck, just lucky it didn't wipe anyone out on it's way.

 

[aczlan]

I was going to chappell tractor today and got into a bit of a traffic jam.When I got up to the cause I snapped a phone pic,
http://i147.photobucket.com/albums/r287/257nh/0428081347a.jpg
I didn't even see the tow vehicle but when I got past it I looked back and there was a kubota still chained to the trailer.

is it me or it there s LOT of space behind the rear axle??? normally the front axle is at least halfway back, there it looks like the back axle is a little less than halfway back...

Aaron Z

 

[257NH]

Aaron I think it's probably a tilt trailer.

No pun intended lol

 

[Soundguy]

Still... almost looks like it needs 2 more axles back there though... that's alotta space behind the rear axle...

soundguy

 

[stayalert]

Timely as I'm helping load an deliver some equipment "won" at Saturday's gray's auction in Fairlee.....We're holding out for tomorrow as its supposed to clear up somewhat.

 

[257NH]

Still... almost looks like it needs 2 more axles back there though... that's alotta space behind the rear axle...

soundguy

Agreed,It does look a little odd,I wasn't sure if it was because we were seeing it in a position were not supposed to see a trailer in or not

 

[257NH]

And another genius,this one thought it was ok to go double the speed limit on a ramp from one major highway to another 495N to 93N.I missed it by 10 minutes or so, Thankfully.
http://i147.photobucket.com/albums/r287/257nh/0425081143b.jpg

 

[Charlesaf3]

first pic looks like a jacknife, no?

 

[Jeff244]

I used to have a triple axle tilt trailer similar to that one. One time I sent a driver to pick up a large self propelled sheepsfoot roller. The dealer loaded the machine and put it too far back. There must of been up pressure on the pintle hook because the trailer separated from the truck on Rt. 94 about 20 miles north of Chicago. It went into the bank on the side of the road away from the road before starting to head towards the road again. Luckily the front of the trailer got buried in the embankment before getting on the road again. The machine flew off the trailer. A lot of damage to the machine, over 10k I believe and minimal damage to the trailer. Very scary. When I looked at the accident site, I realized how lucky we were that the trailer didn't make it back on the road. The driver never forgot to check the hitch again, and I never forgot to remind anyone about it.

Jeff