Hi I am in the market for a new tractor i currently own a ford 6610 cab 4wd loader. I want to replace with 90-100hp with cab, wet clutch, loader for a dairy farm on rolling country. I have been looking at the Deutz 420 and the Fergi 5430 which one would you recommend:confused3: and why
replacing my tractor what should i buy
- Thread starter Yellowfin
- Start date
- Views: 809
Turbys_1700
Elite Member
Most of the posters on here, including myself, will not have any experience with either the Deutz or Fergi due to limited dealer support and size of the tractor...
I assume that you have close dealer support on these two units?
What about parts and service?
Around here my closest dealers are Kubota, New Holland, Mahindra, Massey, and LS...
Deere and Case/IH are is about 35 miles away so those would be considered also...
If I was in the market for a new tractor it would be one of those...
Of the two that you have mentioned I do know that Deutz is a major player in Europe...
I know nothing about Fergi...
I assume that you have close dealer support on these two units?
What about parts and service?
Around here my closest dealers are Kubota, New Holland, Mahindra, Massey, and LS...
Deere and Case/IH are is about 35 miles away so those would be considered also...
If I was in the market for a new tractor it would be one of those...
Of the two that you have mentioned I do know that Deutz is a major player in Europe...
I know nothing about Fergi...
Bigfoot62
Veteran Member
- Joined
- Aug 5, 2008
- Messages
- 2,283
- Location
- W. Central Louisiana
- Tractor
- JD 5090M; JD 5085M; JD 5083E; NH TN70A; Ford 2600
You don't say where you are located, or how you narrowed your search to those two brands, but I would suggest you look at some others.
Stuff happens. And, when it does, how long will it take for the parts to make it here on the "slow boat?" Trying to save a few bucks could bite you in the long run.
I've bought two tractors in the last 4 years, so I've done the research and asked the questions, etc. I bought a NH and a JD.
From your specs, it would have to be the JD because of the cab. Nobody makes a cab like JD.
Check out the JD 5095M.
Stuff happens. And, when it does, how long will it take for the parts to make it here on the "slow boat?" Trying to save a few bucks could bite you in the long run.
I've bought two tractors in the last 4 years, so I've done the research and asked the questions, etc. I bought a NH and a JD.
From your specs, it would have to be the JD because of the cab. Nobody makes a cab like JD.
Check out the JD 5095M.
