Hi, I have a Kubota B7100D, the model of which was the first 4-wheel garden tractor built. The old hubs were wore out so I purchased new. The new ones are of a much improved design, but If I install them with the furnised hardware, the stud threads are recessed in the nut (2) threads, it certainly does not look correct. The old hubs had a set screw to tighten the "hex on the axle and were steel. The new ones are brass with a wedge type assembly for the axel lock. Not sure if the flatwasher is a spacer to prevent the hub from cracking or a normal installation of flat, lock, and nut.
Regardless, the studs are only long enough to attach the lug nut as was on the original hub. Help!
Thanks, cjdiehl
Regardless, the studs are only long enough to attach the lug nut as was on the original hub. Help!
Thanks, cjdiehl
