Working with a friends T5C. Everything WAS working and suddenly no hydraulics to any cylinders. Hydrostatic drive works and power steering, just no outriggers/bucket/backhoe.
Oil level is full. Pulled hose off at the backhoe manifold and zero pressure. Removed plug at gear pump to where I could barely see the gear teeth, then bumped the motor. No movement on the gear teeth.
Unless someone sees something I'm doing completely stupid, I'm guessing I've somehow stripped the main shaft interface with the gear pump. If so, is this a gear pump replacement or a shaft replacement? If shaft, am I looking at pulling the entire hydraulic assembly out of the frame?
Oil level is full. Pulled hose off at the backhoe manifold and zero pressure. Removed plug at gear pump to where I could barely see the gear teeth, then bumped the motor. No movement on the gear teeth.
Unless someone sees something I'm doing completely stupid, I'm guessing I've somehow stripped the main shaft interface with the gear pump. If so, is this a gear pump replacement or a shaft replacement? If shaft, am I looking at pulling the entire hydraulic assembly out of the frame?