no hydraulics after clutch repair

[Gary Beason]

Howdy,

I am a new member, and about a week ago I was trying to get info on why my tractor was positive grnd. A few responces came back at me from soundguy and more. I still haven`tgot that straightened out yet. I put a newer battery onit and wired neg. grnd. and pollerized yhe gen. like soundguy said to do, and I am getting a good reading on volt meter.
I had the tractor apart to replace the clutch`s and all the seals. Now, I have no hydraulic`s for my three point. I know it needs to be bleed, Can some one please tell me how to do that? It is a basic 2000, no frt. loader or any thing else. I have put fresh fluid and I am ready to finish it up.


Thanks, Chief1

 

[J_J]

If the pump input port is flooded, then just operate the hyd to purge the air.

You may have to go through about 5 to 10 cycles.

 

[Gary Beason]

If the pump input port is flooded, then just operate the hyd to purge the air.

You may have to go through about 5 to 10 cycles.

Thank you so much, I moved the lever up and down 21 times before it started working. You are a life saver.




chief1

 

[RickB]

Remove the 1/4" pipe plug on the hydraulic pump head and crank the engine without starting until oil flows from the port.