drs1023
Member
I have a circa1980 NH L775 skid steer. It has an air cooled Wisconsin V-4 around 60+ HP which has had an LP gas conversion since (it appears) it was new. I bought it not running due to missing some parts and a bad LP regulator. With some work and guessing, it runs fine, but the entire throttle linkage and governor setup is missing. I currently throttle it with a push/pull cable (lawn mower style), but that doesn't allow the governor to work. The rpm's run up and down depending on load, and it needs steady input and proper governing to be safe to operate. I have searched the: internet for photos of what I need to take care, but no luck. I also searched a few dozen pages of forum posts to no avail. All help appreciated.
