Stampeder
Gold Member
- Joined
- Dec 2, 2006
- Messages
- 317
- Location
- East Texas
- Tractor
- Montana 4940C, FEL, Quick change 3 point factory hitch, pallet forks, grapple, 50 gal tank sprayer, Bush Hog PHD
I just got a Ford IO-95 cultivator "thrown in on another deal". Well it cost me $50.00 but I consider it a throw in.
I can't read the serial number but I was able to read the part number.
I have a couple of items that need to be modified before I can use it. One is the spacing between the pins and the frame.
My tractor (a 50 hp Montana) has a really unique and very handy quick change system that uses balls that slide over the conventional Cat 1 pins. Anyway the mounts at the end of the three point arms are a little large for the spacing so I will have to add a little to the length of the 1/2 X 2 bar where the pins attach and move the pins forward at least an inch.
I believe this thing is at least 60 years old so I have the usual rusted bolts I am working with.
Anyone with any information on this? Any help would be greatly appreciated.
Glenn.
I can't read the serial number but I was able to read the part number.
I have a couple of items that need to be modified before I can use it. One is the spacing between the pins and the frame.
My tractor (a 50 hp Montana) has a really unique and very handy quick change system that uses balls that slide over the conventional Cat 1 pins. Anyway the mounts at the end of the three point arms are a little large for the spacing so I will have to add a little to the length of the 1/2 X 2 bar where the pins attach and move the pins forward at least an inch.
I believe this thing is at least 60 years old so I have the usual rusted bolts I am working with.
Anyone with any information on this? Any help would be greatly appreciated.
Glenn.
