new member

[btuchman]

Hi All,
I have kubota L3130 I purshased a few years old.
Last year I purchased a york rake, then a used post hole digger that I fixed up and it works fine.
Yesterday I picked up a hardly used 5' Bush Hog rotary cutter . Been sitting in the weeds for a year.
Did some clean up, greased it up, etc.

I plan to get a slip clutch for it.
Just used it today and took it easy.
Needs a few new grease fittings.
I welcome any tips or suggestions
Thanks
BT

 

[HEC]

Welcome to the forum , sounds like you are doing a good job already . When you get your slip clutch just be sure it is set properly , if it is a new one it will give directions on how to do that if you don't know already . Stay safe , if you any specific questions just ask and there are many here who are more then welcome to help you out .

 

[deerseeker001]

Welcome from Wisconsin

 

[mguitas]

:welcome: