New Holland 269 Baler Tying problems

[sewdarn]

I have a New holland 269 Baler that will not tie on the left side any ideas on how to fix thia asap

 

[zzvyb6]

Twine tension too light out of twine box. Tucker fingers not placing twine on the twine disk, twine disk not holding the twine end, billhook not opening to engage twine ends, needle out of position relative to knotter frame, scraper not wiping knot off the billhook properly, just to name a few. You are lucky to have one working, so, make the other one perform step by step lust like the working knotter. Best way to check this is by rolling it over by hand at a VERY slow speed and checking each step discussed above.