New floor mats

[nbking]

Made these from the thinner size stall mats at tractor supply. Stole another person's idea, but definitely a keeper.

 

[K5lwq]

Very nice!

 

[nbking]

I had previously done the spray rattle can bedliner but wasn't holding up, and was still slippery hopefully this will be better.

 

[K5lwq]

That will work well. I used it for a bed mat on my truck. It has performed perfectly.

 

[the old grind]

I don't care where the idea came from. The OP's execution is commendable. 5/5

 

[Thomas]

You'll like the difference.

 

[arkydog]

just curious, how did you cut them out and make the holes? very professional job!!

 

[nbking]

Utility knife, with a couple new blades. I used a cardboard template, then once I had the mat cut out and in place, crawled under and used a sharpie to mark the holes. A kinda dull drill bit, that would heat up and melt the mat as it went through. Then on the bottom side I used a step bit to open the holes a bit to fit over the stock holes on the floorboard.

 

[Sportsman762]

nbking that is one of the nicest floormat installs that I have ever seen. Great job.

 

[jonsstihl]

Nice job. You just don't see that kind of attention to detail anymore.