need a little more hyd flow

[Harold B]

I have got a LK 2554 and the hydraulics all check out good with a flow rater and pressure. I am looking for a few more gpm.

Is the LK 3054 pump shaft the same diameter and spline?
Is the mounting bolt pattern the same?
I am not too worried about the inlet and outlet porting, i can fab these to fit.

Now, beforew we go into the flow/heat issue, please don't bother with that.
I work on heavy equipment and have a very sound understanding of hydraulics and hp requirements, pressure compensated valving, radial and axial piston hst pumps, closed and open center systems etc...

If someone can count the splines and measure the diameter of the shaft and also measure the mounting dimensions, i would greatly appreciate it.

Thanks everyone

 

[JoelD]

I bet if you call kioti and ask for technical assistance they may be able to tell you interchangeability.