woodlandfarms
Super Member
- Joined
- Jul 31, 2006
- Messages
- 6,139
- Location
- Los Angeles / SW Washington
- Tractor
- PowerTrac 1850, Kubota RTV x900
So, PT made a mistake when they built my mower, and the spare bolts for moving the blades that are supposed to be on the outside are on the inside of the stump jumper.
A friend swung by last night and was looking at the fact I have to tear the whole darn thing down to get the bolts reversed.
He said why don't I just use an easy out and push them into the stump jumper. Let them just lay there. It would make a bit of noise but nothing else (in his opinion). When it comes time to replace the bearings then I can pull the bolts out.
The reason to pull the bolts out is to make a bumper for the blades. They are getting stuck under the jumper as they are now flared.
Carl
A friend swung by last night and was looking at the fact I have to tear the whole darn thing down to get the bolts reversed.
He said why don't I just use an easy out and push them into the stump jumper. Let them just lay there. It would make a bit of noise but nothing else (in his opinion). When it comes time to replace the bearings then I can pull the bolts out.
The reason to pull the bolts out is to make a bumper for the blades. They are getting stuck under the jumper as they are now flared.
Carl