somanytractors
Silver Member
I have an mf65. The number for the tractor on the plate by the battery are
CNDW 701 302
There is no tag on the motor.
The only numbers I can find on the block (left side) is C37112210Y and below that is MC22827
I've attached a pic of the tag on the injection pump but it's pretty beat up and hard to read.
I think this is an AD4.203 because everything I found points to the 4.203 and when I looked up the kit the AD had the cupped pistons like this motor has while the D had flat top pistons.
The liners measure about 3.66 inside. Not sure what they should be.
I just want to make sure which one it is. I could be completely off and it may be an entirely different motor.
Also are these pretty easy liners to get out or are they going to put up a fight? Debating wether to change the liners or just put rings and/or pistons in it. It runs great, starts easy, but it smokes a lot and blows oil out the dipstick even with the valve cover off. I haven't got the pistons out yet but from the top the liners look pretty good visisbly. No gouges or anything.
Any help is greatly appreciated!
Thanks
John
CNDW 701 302
There is no tag on the motor.
The only numbers I can find on the block (left side) is C37112210Y and below that is MC22827
I've attached a pic of the tag on the injection pump but it's pretty beat up and hard to read.
I think this is an AD4.203 because everything I found points to the 4.203 and when I looked up the kit the AD had the cupped pistons like this motor has while the D had flat top pistons.
The liners measure about 3.66 inside. Not sure what they should be.
I just want to make sure which one it is. I could be completely off and it may be an entirely different motor.
Also are these pretty easy liners to get out or are they going to put up a fight? Debating wether to change the liners or just put rings and/or pistons in it. It runs great, starts easy, but it smokes a lot and blows oil out the dipstick even with the valve cover off. I haven't got the pistons out yet but from the top the liners look pretty good visisbly. No gouges or anything.
Any help is greatly appreciated!
Thanks
John
