CharlieDelta
Bronze Member
I made a clutch inspection plate for my MF135.
I have scanned the plate. I then cleaned the scan up in a drawing program. I would add 3 to 6mm to the edge since its rough ground with a angle grinder. Please check the hole sizes and location they seem alright on my MF135 but had to file some holes to get a perfect alignment
Print out as original size and it should be pretty close.
I used a gasket and drilled a hole for a cotter pin to drain the leaking from the main seal and drip the oil away to protect the clutch.
Please report if the drawing is crap then I will remove the file if its wrong. Mine is screwed on so I am sure it will be OK. I dont know if there was differences between all the different models of the MF135.
I have scanned the plate. I then cleaned the scan up in a drawing program. I would add 3 to 6mm to the edge since its rough ground with a angle grinder. Please check the hole sizes and location they seem alright on my MF135 but had to file some holes to get a perfect alignment
Print out as original size and it should be pretty close.
I used a gasket and drilled a hole for a cotter pin to drain the leaking from the main seal and drip the oil away to protect the clutch.
Please report if the drawing is crap then I will remove the file if its wrong. Mine is screwed on so I am sure it will be OK. I dont know if there was differences between all the different models of the MF135.
