I recently purchased an MC35 with less than 200 hours on it. First thing I did was change the hydraulic filters and fluid. Went with OE filters and recommended fluid.
I'm having an issue where after I run the machine for a period of time, the fluid starts blowing out the vent located at the top of the trans housing.
Do these vents go bad? And, is there any common underlying issues that may be causing this to happen?
Thanks!!
I'm having an issue where after I run the machine for a period of time, the fluid starts blowing out the vent located at the top of the trans housing.
Do these vents go bad? And, is there any common underlying issues that may be causing this to happen?
Thanks!!
